Jump to content
TUFLOW Forum

Tyrone.Thomas

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Tyrone.Thomas

  • Rank
    Member
  1. Hi Peter, Thanks for your reply. I've attached the csv I'm using below - if you work it out, that would be extremely helpful!Arch_culvert.csv Cheers!
  2. Hi TUFLOW family, I have a question regarding modelling older arch culverts in TUFLOW where the bottom of the culvert contains curved edges (see attached image). For the culvert I'm currently trying to model, when I include the curved sections in the the required HW table, TUFLOW throws the following error: https://wiki.tuflow.com/index.php?title=TUFLOW_Message_1343. To get around this, I made the sides completely straight - and that worked fine, but I'm concerned that the flow through the culvert may now be overestimated. Modelling the culvert this way (as an irregular culverts in a 1d_nwk layer) obviously has constraints when H values don't always increase. Does anyone have a solution to a way around this problem? Given there are a lot of historical 'arch' culverts around Australia, this may be a limitation if the curved sections cannot be modelled.
×
×
  • Create New...