Search the Community
Showing results for tags 'gridded rainfall'.
Found 1 result
We have recently become aware of an issue affecting TUFLOW GPU simulations using the new gridded rainfall inputs. If the map output interval exceeds the interval in the rainfall grids, then the applied rainfall boundary condition is not updated. Choosing a map output interval that matches or divides into the boundary rainfall data interval will alleviate the issue. For example, if the gridded rainfall has a grid every 30 minutes, a Map Output Interval of 30, 15 or 10 minutes will all work. It is also important that the start map output time matches the gridded rainfall input start time. This will occur by default, though may be altered if a user defined Start Map Output time is specified. This does not affect TUFLOW “classic” simulations and the issue will be corrected in the 2016-03-AB release which will be available within the next month. If you're concerned about large file sizes resulting from your map output interval being reduced to fit your rainfall data interval you can use an output zone. For example with a 10 minute rainfall interval an output zone can be defined with an output interval of 10 minutes and the entire model output can be 1 hour. Again this work-around will only be required until the 2016-03-AB release. The 2016-03-AA release has the option to output the instantaneous rainfall rate and cumulative rainfall can be output with the RFR and RFC output types respectively. These can be used to cross-check the results. For example to output the depth, levels, velocities, rainfall rate and cumulative rainfall the .tcf command would be: Map Output Data Types == d h V RFR RFC Please contact firstname.lastname@example.org if you have any queries relating to the above. Regards TUFLOW Support Team