Jump to content
TUFLOW Forum
groganm

Modelling Underground Tanks and Flow Control Structures

Recommended Posts

Hi All, I'm attempting to convert a WinDes model to ESTRY. I've managed to get the pipe network and all the manholes in fine, however the model has a large number of tanks with Hydrobrakes on which I need to model.

For the Hydrobrakes I was thinking of using M channels, and for the tanks I was going to use R channels with dimensions set to replicate the tank areas and levels.

Is this the best way to model these assets? Or does anyone have any advice to help with modelling these?

Any help welcome, thanks.

Share this post


Link to post
Share on other sites

Hi,

 

I'm not that familiar (or should I say not at all familiar) with WinDes. However, for the tanks, rather than use a "R" channel, I would suggest using a "NA" (nodal area) type object in the 1d_tab format (the same used to specify cross-sections).  This can be used to define a custom height varying area table in order to correctly model the storage. An example is below (for a very odd shaped tank):

 

Height, Area (m2)

1.0, 1.0

3.0, 4.0

5.0, 1.0

 

For the hydrobrake, if the flow is controlled by both the upstream and downstream water levels, then a Matrix ("M") type channel may be required.  However, if is is only dependent on the upstream flow, then this can be simplified into a "Q" type channel.  This channel type was introduced in the 2013-12 version of TUFLOW (along with the additional of a range of 1D functionality), for more info please see point 40 of the release notes here: http://www.tuflow.com/Download/TUFLOW/Releases/2013-12/Doc/TUFLOW%20Release%20Notes.2013-12.pdf

 

Hope that helps.

 

Cheers

Phil

Share this post


Link to post
Share on other sites

As a follow on to the topic the Q channels are viewed as open channels not pipes so it is not possible to have them connected to manholes. In the WinDes model the flow controls these are representing are directly downstream of manholes so I was having a few issues until I disabled these manholes.

As a future release of TUFLOW will it be possible to connect Q channels to manholes? As the only solution I can think of, adding another very short C, R or I channel between the manhole and the Q channel, is a bit time consuming.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...