Jump to content
TUFLOW Forum
rambo48v

2d_PO line

Recommended Posts

Hi all,

I'm getting started with Tuflow model and have a question: how can I extract results at any cross section after run time (mean that I didn't setup PO line before I run the model)?

To setup and rerun model with new PO line cost a lot of time. 

Thanks,

 

Van Nguyen,

Share this post


Link to post
Share on other sites

Hi rambo48v,

There are a few options available however it will require using third party software.

  • SMS (limited trial version)

Instructions for extracting flow vs time by digitising a feature arc are provided on the TUFLOW Wiki. You may also extract water level/depth over time by digitising a feature point. 

http://wiki.tuflow.com/index.php?title=SMS_Tips#Post_Processing_Results 

Load the 2D results (in DAT format) into the interface. Time-series results can then be extracted using the 'time-series' tool found within the '2D Results Tool Group'. See the help file for further instructions. 

Regards

Steph

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...